Journal of Crop Production and Processing

---

Twenty-two surface soil samples (0-20 cm) from Fars province were extracted by five extractants (i.e., DTPA, 1.5 M NH₄H2PO₄, 0.1 NH₃PO₄, 0.05 MNa2EDTA, and 1% Na₂EDTA) and used in a 7-week greenhouse experiment which was a 22 × 3 factorial with 22 soils (clay 16-63% pH 7.8-8.2 electrical conductivity 0.32-1.78 dS m^-1 calcium carbonate equivalent 28-63% organic matter 1.1-4.9% cation exchange capacity 9-27 cmol kg^-1 and DTPA-extractable Mn 4-24 mgkg^-1), 3 levels of applied Mn (0, 10, 20 mg Mn kg^-1 as manganese sulfate), 3 replications, and soybean [Glycine max (L.) Merr., cv. Williams]. Application of Mn significantly increased top dry weight by 4 to 104%, averaging to about 12% over the control. But the increase in Mn concentration was not significant. Total Mn uptake also significantly increased but the apparent recovery of the applied Mn was very low (i.e., 0.05%). Soil pH, calcium carbonate equivalent, and clay content were found to be the properties influencing the extractability of Mn. The DTPA-extractable Mn, alone (with a critical level of 13 mg Mn kg^-1) or along with some soil properties, was the only form of Mn that could reasonably predict the plant responses.

---

Nitrogen is usually the most limiting nutrient for crop production. Manganese deficiency in some calcareous soils of Iran has been reported. The objective of this study was to evaluate the effect of N and Mn on the growth and chemical composition of spinach (Spinacia oleracea L.) under greenhouse conditions. The experiment was conducted in a soil from Chitgar series (Fine-loamy, carbonatic, thermic, Calcixerollic Xerochrepts). Treatments consisted of factorial arrangement of five N rates (0, 50, 100, 200 and 400 mg kg^-1 as NH₄NO₃) and three Mn rates (0, 15 and 30 mg kg^-1 as MnSO₄) in a completely randomized design with four replications. Plants were allowed to grow for 60 days and a hand-held SPAD-502 chlorophyll meter was used to evaluate leaf chlorophyll status at harvest.

 Results showed that N and Mn application increased shoot dry weight, N and Mn concentrations and total uptake, Mn:Fe ratios and chlorophyll readings, significantly. Nitrogen increased concentrations and total uptake of Zn, Cu and total uptake of Fe in plants, but decreased Fe concentration. Addition of Mn decreased Fe and Zn concentrations in spinach but increased total uptake of Fe and Cu. When maximum dry matter was obtained, the chlorophyll meter reading was about 40. A similar study should be carried out under field conditions before the N and Mn fertilizer recommendations for spinach can be made.

---

To study the effects of foliar application of zinc, manganese and nitrogen on yield, yield components and grain quality of chickpea (Cicer arientinum L.) two experiments, one in autumn and the other in spring were conducted at Research Farm, Shahrekord University in 2009-2010 growing season each as a randomized complete block design with three replications. The treatments were foliar application of zinc sulfate, manganese sulfate zinc sulfate and manganese sulfate mixture, nitrogen and distilled water (as control). The results showed that planting season had a significant effect on plant height, 100-seed weight and seed yield. All measured traits, except plant height, increased in winter compared to spring growing season. This increase was more than 12% for grain yield. Foliar application of nutrients significantly affected seed yield and seed yield components. Foliar application of nitrogen, presumably, through significant increase in number of pods per plant, number of seeds per plant and 100-seed weight, increased the grain yield by 6.2% compared to control. Foliar application × planting season interactions were significant for plant height and number of pods per plant. Foliar application of nitrogen caused a significant increase in grain yield and protein content. Foliar application of zinc sulphate significantly increased Zn content of grains however it did not affect seed yield. In conclusion, foliar application of nitrogen could be suggested for increasing protein and grain yield in chickpea under similar conditions to that of the present study.

---

Nitrogen is usually the most limiting nutrient for crop production. Thus, N fertilizer is widely used by farmers. Moreover, Mn deficiency in some calcareous soils of Iran with high pH has been reported. Therefore, the addition of nitrogen and manganese to achieve the optimum yield is necessary. The objective of this study was to evaluate the effect of N and Mn applications on the availability of some soil nutrients under wheat (Triticum aestivum L.), corn (Zea mays L.), and spinach (Spinacia oleracea L.) plants in greenhouse conditions. In a factorial test, five levels of N (0, 50, 100, 200 and 400 mg/kg soil as NH₄NO₃) and three levels of Mn (0, 15 and 30 mg/kg soil as MnSO₄) in a completely randomized design with four replication were applied. Corn, wheat and spinach varieties were sc₇₀₄ Falat and Spinacea spp., respectively. After eight weeks, total N content and DTPA-extractable Mn, Fe, Zn and Cu of soil were measured.

 The results indicated that N and Mn applications increased Mn-extractable of soil in three cultures but didn’t affect the soil total N. Nitrogen application in corn increased available Fe in soil. Mn application decreased extractable Zn and Cu of soil in wheat and soil extractable Cu in corn.

---

Soil pollution and accumulation of heavy metals in crops in industrial areas are the most important bioenvironmental problems that threaten the life of plants, animals and humans. The objective of this study was to determine Ni, Mn and Cd distribution in soil and crops shoots around the Mobarakeh Steel Plant. In this study, we separated 50 zones based on soil utility maps taking into consideration the dominant wind direction (south-western to north- eastern). In each zone, soil was sampled at 0-5, 5-10, 10-20 and 20-40 cm depths (200 samples) and DTPA-extractable concentrations of Ni, Mn and Cd were determined in soil samples. Also 36 plant samples from shoots of 18 main crops were collected in the region and the concentrations of heavy metals were determined in crop samples. Results showed that maximum DTPA-extractable concentrations of Ni and Mn were in the northeast of the region in the 0-5 cm layer (4.2 and 312 mg/kg.soil, respectively) and decreased in 5-10,10-20 and 20-40 cm layers (2.7,2.7,2.1 and 200,212,146 mg/kg.soil, respectively). The concentrations of Ni and Cd in shoots of crops were undetectable with atomic absorption method. The concentration of Mn in rice shoots was 716.6 mg/kg.dry.m. It was higher than USEPA standards (15-100 mg/kg.dry.m). .

---

In order to investigate mineral manganese forms and their relations with plant responses, 22 soil samples from Fars province (0-20 cm) were in a greenhouse experiment filled in 3 liter pots, and soybean (Glycine max (L.) merr.,CV.Williams) was grown for 7 weeks. Chemical forms of manganese were determined in soils by warden and Reisenauer sequential extraction method (readily soluble, weakly adsorbed, carbonate bound and oxide bound extracted with Ca(No₃)₂, Ca DTPA +Na₂B₄O₇, HNO₃ and NH₂OH. HCl, respectively) after harvesting the plants. Results showed that the amount of Mn in different forms was in the following order: Carbonatic Mn >Mn Oxides >Weakly adsorbed Mn > Soluble Mn. Regression equations between soil properties and Mn forms showed a significant correlation between calcium carbonate equivalent and carbonate bound Mn. Significant correlation between Carbonate bound Mn and concentration of Mn in the aerial part of soybean showed that this fraction plays an important role in plant nutrition.